Anaerobic Resin - Grease remover and activating - Spray 150 ml
Anaerobic adhesives
This product reduces considerably the cure time:
- in presence of passive metals such as zinc, chrome, nickel, special metals
- in presence of non-metallic materials such as glass, plastic materials, ...
- in case of irregular, grilled and grooved surfaces
- in case of assembling elements which have an important tolerance.
Instructions for use
- The pieces have to be dry and free from dust.
- Apply a few drops on the to be assembled pieces. Than assemble.
- The total polymerisation is obtained after 12 hours. The assembled pieces are manipulable after 10 to 20 minutes and they can be put into service after 3 hours.
Composition
Anaerobic adhesives
Covered surface
+/- 100 cm² (if joint of 0,1 mm)
Storage
No particular storage conditions. Avoid very high temperatures. Ideally 10 up to 17°C.
Anaerobic adhesives
Covered surface
+/- 100 cm² (if joint of 0,1 mm)
Storage
No particular storage conditions. Avoid very high temperatures. Ideally 10 up to 17°C.